Amateur Radio – Golb.be

Z-Match – Soldering It All Together

Now that the two toroids are prepared, and everything is already mounted into the enclosure lid, we can start soldering…

The project descibes to use a FT37-43 toroid. This toroid is manufactured by Amidon. I’m using a similar toroid made…

Green wire, 5 turns Start with the green wire. In the parts list it is stated this wire should be…

The original design features the Radio-Shack P/N 270-233 box, wich measures 5″ 1/16 x 2″ 5/8 x 1″ 5/8. I…

The capacitors that are used in this ATU are CMB-443BF’s. You can find them on AliExpress. These capacitors are used…

Participate in contests with ease with your QCX. Use N1MM+ to log your contacts and to send signal reports. With…

Using the CAT interface of the QCX it was already possible to retrieve it’s frequency in N1MM. I made great…

I released the project files of the Icom External Keypad V1.21. You can find them on the Icom External Keypad…

On the Belgian Facebook group “AliExpress voor makers” I saw a powerbank pass by with quite a number of good…

To power up a QCX or a QCX+, you need a power source that provides a voltage between 7 and…

I released the project files of the Icom External Keypad V1.20. You can find them on the Icom External Keypad…

To connect the external keypad to your Icom radio you’ll need to make a connector cable. For this we use…