Participate in contests with ease with your QCX. Use N1MM+ to log your contacts and to send signal reports. With the CAT & Key interface you connect the CAT and Key of your QCX with only one USB dongle. I found this simple schematic by Guiseppe IU8EUN, in a post on the QRPLabs group.io forum and decided to make it into a PCB.
The settings that work best for me are the following: Kenwood TS-480, 38400 baud (bps), Parity N, DataBits 8, Stop Bits 1, DTR (pin 4) CW, RTS (pin7) Always off.
Porting the Autmatic Magnetic Loop Tuner project to the Teensy 4.0 platform Building a Nano…
In de kringloopwinkel een spiksplinternieuwe Opinel 9 vinden, met het originele antidiefstal stripje er nog…
Now that the two toroids are prepared, and everything is already mounted into the enclosure…
The project descibes to use a FT37-43 toroid. This toroid is manufactured by Amidon. I'm…
Green wire, 5 turns Start with the green wire. In the parts list it is…
The original design features the Radio-Shack P/N 270-233 box, wich measures 5" 1/16 x 2"…
